ummm i guess i need some insight

1112 Views 6 Replies 4 Participants Last post by lucky, Nov 2, 2010

lucky

Discussion Starter · Nov 2, 2010

ok i guess i am having a blond kind of day here i was going to adjust my cam chain and tappets but for the life of me i cant figure out what the settings are i found this on the old site

"inlet valves...............0.08mm

exhaust valves..........0.10mm"

and trying to figure out if my 008 and 010 are the right feeler gauges to use because i dont have the type that say 0.008 or what not unless its the same as what i have

so i need some advise any other day i would know right off jump street and i thought today would be a good day to do it sense my bike is going to be done until i get a tire so what the

because under the 008 it says 203mm and under the 010 it says 254mm so i am lost

Save

1 - 4 of 7 Posts

lucky

Discussion Starter · #3 · Nov 2, 2010

kingston73` said:
Sounds like your gauges just don't have the decimal points on them, the 0.008 is inches which converts to .203 mm.

ok so the 008 is the same as the 0.008 and should work fine then if thats what your saying king because i dont want to screw up my engine at all if ya know what i mean

like i said any other day i would know this right off the top of my head (being a certified small engine tech and all) but today is an off kind of day

Save

lucky

Discussion Starter · #5 · Nov 2, 2010

ok then what should i do?? do i not have the right ones or what??

Save

lucky

Discussion Starter · #7 · Nov 2, 2010

ok so i found another set that has the .003 and .004 so i should be good to go thanks guys

Save

1 - 4 of 7 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month