Honda CX 500 Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
94 Posts
Discussion Starter · #1 ·
all 4 of my turn signal rubber stemms were bad so i ordered 4 new ones"aftermarket" i saw a post on the old site about the holes being too small to pull the 3 wire bundle thru. I ran into the dame issue...ended up up pulling them tru the wire wrap with some monofilement off my fishing reel lol didnt work too bad #2 i was reading about the HID headlite conversion..i had the H/L out to rewire my signals i realized the h/l is just a standard sealed beam?? didnt the 83 650's come with a H4 standard? I guess if i want to switch to HID i have to get a new reflector lens set up for the H4 1st... no wonder the H/L was so poor LOL live and learn i guess Mike
 

·
Super Moderator
Joined
·
15,414 Posts
For some reason I think the cx650c's had a sealed beam. There were a few random kits to upgrade it to H4 but stock should be sealed beam were everything else at that time should have been h4.
 

·
Registered
Joined
·
762 Posts
Correct - they came with a sealed beam from the factory. There were/are conversion kits to switch them over to H4...some discussion of part numbers etc. were on the old board.
 
1 - 3 of 3 Posts
Top