Honda CX 500 Forum banner

Turbo activating alerts

670 Views 0 Replies 1 Participant Last post by  RIQUE
Hey Folks, I have managed to get the bike to run and idle very smoothly. I disconnected the P2 harness and pluged it up again. Bike started on a dime vrooom! While bike is idle no computer alarms

or System Fuel lamp on. Nice. However, if I accelerate the bike, the fuel system comes on. and W01 appears on the computer. My question, I suspect the waste gat BUT, the Turbo display

is not maxed out as it should when this happens. Did I mention the bike is now at an altitude of 12000 feet above sea level or 3600m asl.

Thnks much fellas.

1 - 1 of 1 Posts
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.