Testing Sensor guidlines

906 Views 1 Reply 2 Participants Last post by homerrod, Mar 10, 2011

RIQUE

Discussion Starter · Mar 10, 2011

Hello Folks, I have been doing some serious reading to start to test my P2 sensor due to the Fuel System Light on and the W 0 1 fault. The turbo waste gate is being soaked and I have yet to test the P2 sensor. I dont' have a testing harness and need to know how to go about testing from the back and what cables. I have read the old archives but can't find instruction.

One more question. If the waste gate was in fact stuck, the Turbo led should be maxed out uppon engine start right? or not necessarily?

Riq

Save

1 - 1 of 2 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.