Honda CX 500 Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
967 Posts
Discussion Starter · #1 ·
don't have the bike available now, but what size and thread pitch are the screws found on the inlet flange of each cylinder--the ones used for synchronizing the carbs? I might have the proper hose barbs available, but just need to verfiy so I grab the right ones!



Are proper/designated hose barbs available for this? What have you guys used in the past? please post pics of your set-ups if you have them!



Thanks,



Rick
 

·
Registered
Joined
·
967 Posts
Discussion Starter · #3 ·
Thanks for the quick reply!! that's similar to what I dreamed up in my head--good to know I am on the right track!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top