Honda CX 500 Forum banner
1 - 3 of 3 Posts

· Registered
960 Posts
Discussion Starter · #1 ·
don't have the bike available now, but what size and thread pitch are the screws found on the inlet flange of each cylinder--the ones used for synchronizing the carbs? I might have the proper hose barbs available, but just need to verfiy so I grab the right ones!

Are proper/designated hose barbs available for this? What have you guys used in the past? please post pics of your set-ups if you have them!


1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.