Honda CX 500 Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
460 Posts
Discussion Starter · #1 ·
So I have been knocking off the rust on my frame and went to remove the swing arm to sand on it also and etc...and this is what happened:
fortunately it is a kobalt and I will get it replaced.



So...any other ideas on how to get if off?
 

·
Registered
Joined
·
2,362 Posts
So I have been knocking off the rust on my frame and went to remove the swing arm to sand on it also and etc...and this is what happened:
fortunately it is a kobalt and I will get it replaced.



So...any other ideas on how to get if off?




What am I looking at? Is that a large allen wrench socket set-up? If it is, I would suggest you buy a regular allen wrench and a heavy soft hammer (lead) to break that bolt loose. Then you can use that socket wrench set-up to remove the bolt.
 

·
Registered
Joined
·
2,362 Posts
@ Phil: it is a socket allen wrench

@ David: in the words of the great philosopher homer j simpson D'oh!




D'oh! I forgot the locknut too.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top