The most common problem seems to be an insufficient ground connection. I'll be very surprised if that's not the culprit.
Starter spins on bench but won’t crank bike
Hello new member here and would appreciate any assistance. I live in Guelph Ontario Canada which is about 45 ride from Toronto. My 82 CX500 Custom was my daily driver all season and after sitting for just a couple of weeks won’t crank.
I tried a few known good batteries and even load tested them but wouldn’t crank. Solenoid just clicks. I have full voltage >12V through solenoid (power side). I pulled the starter and cleaned everything, replaced brushes and performed ground mod. On the bench it spins with power but in the bike it doesn’t. I can spin the engine over easily with a small rachet on the crank bolt.
The engine isn’t seized and plugs are out. Could I have a weak starter? I can’t seem to locate a new one online. Any suggestions?
I tried a few known good batteries and even load tested them but wouldn’t crank. Solenoid just clicks. I have full voltage >12V through solenoid (power side). I pulled the starter and cleaned everything, replaced brushes and performed ground mod. On the bench it spins with power but in the bike it doesn’t. I can spin the engine over easily with a small rachet on the crank bolt.
The engine isn’t seized and plugs are out. Could I have a weak starter? I can’t seem to locate a new one online. Any suggestions?
1 - 1 of 26 Posts
1 - 1 of 26 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Honda CX 500 Forum
A forum community dedicated to Honda CX 500 motorcycle owners and enthusiasts. Come join the discussion about modifications, parts, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Top Contributors this Month
View All
Sidecar Bob
212 Replies
Randall-in-Mpls
158 Replies
CXPHREAK
115 Replies
Recommended Communities
