Honda CX 500 Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
41 Posts
No, it's a two-piece stock seat. The rear seat with the grab handle and the hard-to-find cowl removes to expose the took kit and some wires between it and the rear fender. Here's a larger picture of it.





Dan
 

·
Registered
Joined
·
41 Posts
Yup, that's exactly it. The back removes in case you want the trunk there.



Mine used to be an Interstate model, but I wanted a cruiser, so I stripped it naked. I had both seats, plus the trunk extender for the full sized trunk. I had to locate the grab handle and the rear seat cowl though to complete it, both of which are hard to find. Now, I can swap the rear seat for the smaller trunk if I decide I need it. I don't like passengers on my bike, so I've been leaving the trunk on it when I used to ride it, though I like the look of the two seats much better.



Dan
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top