Honda CX 500 Forum banner
1 - 13 of 13 Posts

·
Registered
Joined
·
144 Posts
Discussion Starter · #3 ·
yes I’ve seen these before, great job!



But what I’m trying to find is a job where someone cut the chromed fender and welded both ends. See I wanna keep the chrome end. not sure if I’m clear..
 

·
Registered
Joined
·
2,362 Posts

·
Super Moderator
Joined
·
15,416 Posts
Aren't you going to need some holes in the side for where the rear section of the frame attaches to it. You might also clean up your weld and possibly hit it with a bit of silver paint. Even though it will probably never be seen.
 

·
Registered
Joined
·
144 Posts
Discussion Starter · #11 ·
you’re right it needs some easthetic attention. As for the holes, I’ll get the turn lights on the frame and the tail light is a small and light one, so I’ll try to reenforce the two existing bolts and thats it. we’ll see how it turns out.....
 

·
Registered
Joined
·
2,362 Posts
So here what I’ve done. The seat should cover the welded part


Wow! Looks like my welding, but then, I'm going blind.
 
1 - 13 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top