[Reg in Bristol]

Yea. I just found the write up he did. I'll be doing it as soon as I receiv the fan. Who has done it?



The thing I am most interested in is the grinding of the cam end. If it needs to be done do I just hit it with my 4" angle?

I'd suggest a good hacksaw as the heat fron an angle grinder may heat the shaft enough to melt the oil seal.

A bit of a slog I know but I'd take a more cautious approach myself



I have this project in mind myself but it will be controlled by a new electronic temp gauge

I have on the breadboard.

When I have that working satisfactorily it should provide an output to control a fan

ar higher temps