Depends which rim you do it on. I believe the rear has a retaining ring where the front doesn't.
Removing old wheel bearings
I started working no my wheels last night. I was getting a bit tired, so I did not try to much, but I was not able to get the old wheel bearings out. I did not try heat as I am afraid the heat may damage the finish on the wheels. I am probably being too paranoid about that. Anyway, how do you all remove wheel bearings? Any tricks to make it easy?
1 - 2 of 8 Posts
Get a thinner punch that you can put at a tighter angle to find that lip. The center piece kind of floats.
If you still cant get it I believe you can take the bearing apart but you're destroying it. Not that it will be used again. Get the center ring out of there and punch out the opposite side.
If you still cant get it I believe you can take the bearing apart but you're destroying it. Not that it will be used again. Get the center ring out of there and punch out the opposite side.
1 - 2 of 8 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Honda CX 500 Forum
A forum community dedicated to Honda CX 500 motorcycle owners and enthusiasts. Come join the discussion about modifications, parts, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Top Contributors this Month
View All
Sidecar Bob
221 Replies
Randall-in-Mpls
164 Replies
CXPHREAK
111 Replies
Recommended Communities
