Honda CX 500 Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
851 Posts
That was done by CNC mill not lathe. The five small bosses could not be turned. Looking closely you can see the steps the mill made in each pass .070" (1.778mm)you can write the CNC program to make the steps much smaller and closer that would yield far fewer tool marks and a very smooth finish. The dollar cost of that would be far more expensive than these cost. I "bench" finished the tool marks by hand, it took about 3 hours extra but I saved money.

Cheers, 50gary
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top