Honda CX 500 Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter · #1 ·
Now, during the rebuild of the cx 650e, I have noticed that the intake ports on the cylinder heads are quite rough, would there be anything to gain in polishing the ports up? Any pitfalls that should be avoided when polishing?



Your comments are always appreciated.



Jacques
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top