I recently have purchased a cx500 shitter. Although it looks horrible, The motor should run once I get everything squared away. upon buying the bike, I said fuc it I'm gonna figure out a different way to wire the bike. Then realizing oem wiring would be the easiest way... or at least I think so. Thing is in horrible condition, throttle, choke, brake lines all corroded out. fuel lines as well and the coolant bottles cracked. master cylinders locked up. I pretty much stripped this bike to its bare ass and now I'm fiending to give this thing a rip. I've thrown the carbs in the ultrasonic cleaner and cleaned it very well although the outside of them still look like shit. except the butterfly on one side gets stuck. And I'm almost certain it will leak fuel somewhere. Idk just throw me in a general direction so I don't have to look at this shitta like this for that long. here are the photos and i hope this forum will get somebody to reach out.