Honda CX 500 Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
28 Posts
Discussion Starter · #1 ·
Hey Folks,
The original set of balls and races seem to be in good shape so I'd like to keep them. but since I spilled the lot of them across my garage floor the question is how many ball bearings do I use on top and bottom. There is quite a lot of space left when I use 18/19. Somebody else suggested filling in the race and subtracting 1?

I'm feeling a little bit out of control with the instruments, cables and wires hanging every which way off of the bike. It's looking a lot like a birds nest and I'm worried about reassembly. Any systems to facilitate an easier time? Thanks!:bom:
 

·
Registered
Joined
·
24,386 Posts
put in all balls racing tapered bearing kit

it will be a big improvement over the old worn races and balls

as for a good system for the bike

plan waht you are going to do and read all about it thay it wont be such a big mess to fix

post some pics of what you have done so we can guide you
 
1 - 2 of 2 Posts
Top