Honda CX 500 Forum banner
1 - 11 of 11 Posts

· Registered
Joined
·
73 Posts
Discussion Starter · #1 ·
i juat got a 82 cx500. I wont to remove tach and center lights display. But i dont wont to mess up the wireing do they just unpluge some were on harnes or do i have to cut and tape. the guy i got the buke from hit his barn and mess it up
 

Attachments

· Registered
Joined
·
1,267 Posts
Have you looked in your headlight bucket
Most of these electrics just "unplug" from one another, but then those leads may be taped together later on the line.



The way these bikes are I'd be careful about just cutting wires. Someone who's been there done that should be here soon, with a more appropriate answer for you.



Welcome.
 

· Registered
Joined
·
73 Posts
Discussion Starter · #3 ·
ok i got it off and the bike still runns but 1 problem i was all was wording why my tach dent work i found out why the cable is broke and i dont know were it hucks up too
 

· Registered
Joined
·
725 Posts
Your tach connects to the motor behind the rad. A small set screw holds it in position. Sometimes the internal gear may have worn, causing failure, or possibly you have a broken tach cable?
 

· Registered
Joined
·
302 Posts
Mine has done the same when I got it, just order a new tach cable there pretty cheap on ebay and is an easy fix the bolt that goes to the motor is a 10mm and if you use a 1/4 inch drive with about an 8 inch extension with a swivle it makes the process alot easier just from a guy thats been there and done that then you should be all good.
 

· Super Moderator
Joined
·
13,450 Posts
There's a plug that connects all that stuff to the bike. But if you unplug it you will also lose the lights for the speedometer. And if you want some lights they are just simple power wires to a big spiderweb ground wire.
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top