Honda CX 500 Forum banner

1 - 12 of 12 Posts

·
Registered
Joined
·
306 Posts
Discussion Starter #1 (Edited)
I have a box of parts I don't need... these are for cx500's, not GL's
Hoping to sell everything at once to a local to prevent shipping., and save time.

I've got an ad up for the side covers sets that are pictured. (a set could be included)

Cowl with headlight speedometer and tach, (est. $100 complete)
Light tree, temp gauge, voltage regulators,
Light switch, start / run switch, fuse box,
electrical wiring harness's
Vetter fairing lights, glove cover and key,
radiator, radiator cover, fan, coolant bottle,
brake reservoir and caliper

if a local doesn't pop up, then I'll piece out for fair offer.

Cheers, Tim
IMG_2744.JPG
IMG_2745.JPG
IMG_2746.JPG
IMG_2749.JPG
IMG_2750.JPG
 

·
Registered
Joined
·
306 Posts
Discussion Starter #3
no sweat, you got dibs... but this is for a cx...
I'll get it out later and compart it with my GL with a photo.
I may even have a spare GL stand but that'll be tomorrow to check,
 

·
Super Moderator
Joined
·
3,722 Posts
I have a box of parts I don't need for my GL's
Tim you may want to edit your original post to read CX instead of GL.
 

·
Registered
Joined
·
306 Posts
Discussion Starter #5
lol. I did say that I didn't need for my GL's... because there for cx's.. but edited and I clarified, cheers
holy cow, you've been here one day longer than I... wonder what the old forum date was :)
 

·
Super Moderator
Joined
·
3,722 Posts
If only they could find a way to resurrect the older posts. Right Bob?!
 

·
Registered
Joined
·
7 Posts
I wish I was closer! If you do decide to sell parts or ship it please let me know, I’ve searched for 2 years for the right turn signal. I’m 12 hours away on the far side of Idaho. Won’t be that direction again that I know of until December.
 

·
Registered
Joined
·
306 Posts
Discussion Starter #8
IdahoBriGuy… IMG_2770.JPG IMG_2771.JPG IMG_2772.JPG
which turn signal? the rear right on the frame looks like a prior owner welded funky.
others seem good.
 

·
Registered
Joined
·
306 Posts
Discussion Starter #10
MashX… I do have the CX500 stand, but its post is opposite of a GL's...

I do have a GL500 stand, it's lower loop has a crack and needs to be tach welded back.
GL500 and GL650 look the same.
almost same as cx500 except for a slight loop bend difference, & the spring attachment.
IMG_2773.JPG
IMG_2774.JPG
 

·
Registered
Joined
·
306 Posts
Discussion Starter #11
IdahoBriGuy,
looks like your is a newer bike... these cx500 are from 78' & 79',
and the vetter is probably a early windjammer II or III.
 
1 - 12 of 12 Posts
Top