Honda CX 500 Forum banner
Cancel

How do I remove the driveshaft GL500?

5582 Views 10 Replies 8 Participants Last post by  need4steed, 
ChopperCharles
On a CX500, the driveshaft slides right out of the swingarm. The GL500 not so much. How do I get that sucker out? Well, besides a torch, that is. Thanks.



Charles.
Reply
Save
Like
1 - 1 of 11 Posts
DavidfromWisconsin
Charles,



It is possible that you pushed the drive shaft too far in on the GL and it is hooked behind the rear-end gears.



Try turning the shaft as you pull it out of the front.



Also, as a FYI, it will not pull out of the back of the drive shaft on a GL.
See less See more
Reply
Save
Like
1 - 1 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Honda CX 500 Forum
A forum community dedicated to Honda CX 500 motorcycle owners and enthusiasts. Come join the discussion about modifications, parts, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Technical Help Forum General Discussion Member Classifieds CX Customization and Mods Forum Build Threads
Top