I believe you have to take the swing arm off. The knucking on the engine side is to fat to fit through the arm.
How do I remove the driveshaft GL500?
On a CX500, the driveshaft slides right out of the swingarm. The GL500 not so much. How do I get that sucker out? Well, besides a torch, that is. Thanks.
Charles.
Charles.
1 - 2 of 11 Posts
Dumb question, but did you remove the bolt that holds it onto the output shaft?
1 - 2 of 11 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Honda CX 500 Forum
A forum community dedicated to Honda CX 500 motorcycle owners and enthusiasts. Come join the discussion about modifications, parts, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Top Contributors this Month
View All
Sidecar Bob
221 Replies
Randall-in-Mpls
164 Replies
CXPHREAK
111 Replies
Recommended Communities
