[Blindstitch]

33mm. I used some of the generic ones and they were ok except for the one gouging at the cables on the left side of the bike. This was fixed by grinding down the extra material not needed and reshaping it.



They also held the headlight really close to the gauges.

 

[Blindstitch]

With some Led's you need a resistor or similar spiced into your wiring and some you don't.

 

[Blindstitch]

Hey blindstitch, did you add rubber to make those fit tight?

Didn't need any rubbers. But I did upgrade the nut and bolt holding them on. The screw and nut held fine but it became a pain.

 

[Blindstitch]

Doesn't need to be a cx custom. Could really be any large headlight bucket. Mine is from a yamaha 1100. Works just fine.

 

[Blindstitch]

http://cgi.ebay.com/ebaymotors/HOND...5157123QQptZMotorcyclesQ5fPartsQ5fAccessories