It is a good bet that the bearings are due for at least a service of clean and lube, then adjust. most of us take the opportunity while it's apart to just upgrade to the tapered bearings. To raise the front wheel put the bike on the center stand, a bottle jack can be placed under the engine and raise the front wheel for service.
GL500i steering bearings
Noticed a definite front wheel wobble at low speeds, especially with no hands on the bars.
Read some posts about bearings, but had some real basic questions before I start.
1) is it worth just trying to tighten them first and see how it goes? Or should I just replace with a tapered set?
2) is there a full step by step on replacing them anywhere? Do I need any special tools?
3) any ideas on jacking front wheel up without a jack? Don't currently own a jack, but will get one if it's the best way to get the wheel off.
Thanks in advance
(I like pics, so figured others might enjoy thos one)
![Tire Wheel Building Sky Vehicle]()
Read some posts about bearings, but had some real basic questions before I start.
1) is it worth just trying to tighten them first and see how it goes? Or should I just replace with a tapered set?
2) is there a full step by step on replacing them anywhere? Do I need any special tools?
3) any ideas on jacking front wheel up without a jack? Don't currently own a jack, but will get one if it's the best way to get the wheel off.
Thanks in advance
(I like pics, so figured others might enjoy thos one)
