I was wondering if anyone on this forum has tried shimming a monoshock, and if so had any information on the ID and OD of the shims they used. I like my forks much better after adding spacers for preload and was hoping for the same result out back.
GL500 monoshock shim
1 - 6 of 6 Posts
Joined
·
15,400 Posts
The back is a totally different beast.
Joined
·
15,400 Posts
The seals in them are near impossible to get. Just so you know.
Wildmanwill managed to track some down, had to get them overseas I think. I work in the bearing Industry and tried every seal manufacturer I could think of including NOK with no luck, so when he made some available I jumped on it. If all else fails i will just get the Hagon. Right now I can't afford to pay attention so I really appreciate the resourcefulness of people on this site.
Joined
·
15,400 Posts
Well at least you're informed.
1 - 6 of 6 Posts
Join the discussion
