[Farva84]

I'm trying to track down the dimensions of the o ring located between the carb bowl and body that seals the accelerator pump passage. I really appreciate your help!

 

[JAMMAN]

If someone don't chime in I have a disassembled carb set at work and I'm going in tomorrow morning. I can measure it and probably give you the "dash" number. I get viton orings from Mcmaster Carr.

 

[JAMMAN]

It's 1MM thick with a 4.5MM I.D

McMaster Carr # 9262K611

I'm sure it must be a common size and just about any motorcycle repair place would have a vat of them laying around.

 

[Ed Z]

Randal Washington (Randakk.com) could tell ya exactly what size and possibly even sell ya one or two of em... Couldn't hurt to check with him...


Randakk's Cycle Shakk

 

[murrayf]

it is a 5x1.2

look down this page and you will see them all

http://australiancx.asn.au/gallery/albums/userpics/CX500_O_Ring_list-commercially-carby.pdf

HeY ANYONE KNOW HOW TO SAVE THIS HERE SO IT CAN BE SEARCHED on this forum ?????

 

[JAMMAN]

OK they had the wrong one in mine then because I measured it and it was exactly what I posted. Or perhaps it shrunk being smaller in both directions.

An administrator could mark the topic as "sticky" and it would stay on top. A search should bring it up anyway if the database is healthy.

 

[Randakk]

The correct size for that oring is actually 5.0 x 1.3 mm.

 

[ramprat06]

I've stuck the thread, but keep in mind that many don't use the main pages. I don't have time to add it to the WIKI right now, but this would be helpful, perhaps JC or the other WIKI editors can add it.
Thanks.

Joel in the Couve