Honda CX 500 Forum banner
Cancel

Gasket Removal

3582 Views 5 Replies 6 Participants Last post by  MGR1, 
Casey Stangle
Last year I rebuild my CB 450. I spent days trying to get the old gaskets off. I finally used a putty knife that I honed the end to a nice sharp endge. Razor blades will dig into the aluminum. I came across a product in the cabinet called Goo Gone. I assume it is available in the grocery store. I was scrapping off the clutch cover gasket and having my usual amount of difficulty. I put some of this stuff on and let it sit for 20 minutes. The removal effort was reduced by 50%.



Your wife may have some also. Give it a try. Helps out a nasty job.
Reply
Save
Like
1 - 1 of 6 Posts
Shep
bandit said:
shep recomends plain simple paint stripper,cheap,and widely available
Click to expand...


I've used paint stripper for years.Just leave it on for a good half hour and then any half decent knife and a bit of scotchbrite or emery cloth.Remember to neutralize/wipe off the stripper otherwise it will burn the hands.
Reply
Save
Like
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Honda CX 500 Forum
A forum community dedicated to Honda CX 500 motorcycle owners and enthusiasts. Come join the discussion about modifications, parts, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Technical Help Forum General Discussion Member Classifieds CX Customization and Mods Forum Build Threads
Top