Honda CX 500 Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,493 Posts
Discussion Starter · #1 ·
Bought a GL500I wheel off of eBay. Looked a little rusty here and there, but it is old. The problem is, how do I get the axle out? I think the speedo is rusted onto it! I'm assuming the speedo side is not how the axle slips into the wheel, but rather the terminating side? At any rate, the axle and speedo are one




I've been PB Blasting this SOB all night and no joy. Tried whacking it with a rubber mallet, and tried pounding the axle with a hammer through a board.



Any ideas on this one?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top