Honda CX 500 Forum banner
1 - 1 of 1 Posts

·
Registered
1983 cx650E
Joined
·
1,068 Posts
On the '81 Deluxe with Vetter fairing I fashioned lowers out of a black plastic 5 gallon bucket and a circular saw. Each side was about 1/5 round +/- of the bucket. Maybe 6" wide. I attached them to the radiator shroud mounting threads with a lightweight "L" bracket from a hardware store; one on the top hole and one on the bottom hole on both sides of the radiator. the center edge of the bucket slice curved slightly back towards the radiator and the outer edge of each side curved back to the outside of the bike. They were wide enough to throw water away from the pantleg. I traced and cut them to fit pretty snug against the vetter fairing.



I dont' think I have any pictures; but they didn't look that bad at all. Not quite stock or factory looking, but not bad either. Easy to paint also.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top