Honda CX 500 Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter #1
Hi all, I am in Australia and I have just had the glove box lid scanned and printed (but not yet seen thanks to Covid !) a 3D plastic molded one for one of my 3 650s, anybody else interested if it turns out successfully?
 

·
Registered
Joined
·
13 Posts
Discussion Starter #3
hi Dave, once I get it after lockdown finishes I will try and post some photos if it turns out any good.
Kenn
 

·
Registered
Joined
·
1 Posts
Hi all, I am in Australia and I have just had the glove box lid scanned and printed (but not yet seen thanks to Covid !) a 3D plastic molded one for one of my 3 650s, anybody else interested if it turns out successfully?
Hi I would be intersted in one also depending on cost, would always like a spare. I actually found a guy in the UK who had them remade and they are a fantastic job. He improved the latching and even has a lock and rubber seal on it. They are sold as a set so you get the air cleaner as well. The only problem was they were very expensive.
 
1 - 5 of 5 Posts
Top