[trikerrob]

Hello Everyone, As My first post i shall do my best to explain My problems

I have got a 1984 A Reg Cx500C That i had converted into a trike a few years back.

The problem started at the end of last year when the Alternator failed, I had had the Alternator Re-wound, the 2 Fixed Pulsars have been Renewed, the Advance Pulsar assembly has been Renewed and checked, i have tried 2 different CDI units (Both are In working order), all the Electrics have been checked and tested and are working fine . . . . . .

My bike has been stood still for 6 months with Approx 1/2 Gallon of fuel in, But everytime i fix one part and put it all back together agian and Switch her on, It starts but wont run above 3500 RPM approx (although its runs smoothly below) . . . . . it Missfires, cough, splutters and struggles to go any further through the revs . . . . .

So if anyone has any ideas, Feedback would be very muchly appreciated . . . . .



Thanks Rob



(P.s I dont have Much hair left to pull out)

 

[trikerrob]

It's rare, but the filter screen in the tank can get gummed up, you have to drain all the gas, and(preferably) remove the tank to get it out. An EZ-Out works best if it's stuck in there.



Og course it could also be carb relater or a slim chance of electrical, matter of elimination.

I cant seem to get it out, but the fuel is running out of there a plenty. . . .