Honda CX 500 Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi all, been searching the wealth of knowledge from this forum for a while now and haven't come across this question yet? Being that my bike is low miles, the lobes and jounals on my cam are still in really good shape. However, the separate piece on the camshaft that gets epoxied in place and serves as the spline impeller drive and oil/mechanical seal is shot. Assuming I can get the original piece off of the camshaft, is there somewhere I can get an new one of those parts or detail drawings to get the part made?

(Reference 2nd pic down: https://motofaction.org/motorcycles/honda-cx-gl/closer-look-camshaft-honda-cx500-gl500-cx650-gl650)

Thanks,
Nick
 

·
Registered
1978 CX500 "The Grub", 1983 GL650I "Nimbus"
Joined
·
12,089 Posts
Welcome, Nick! Where would you be in MN? We have a lot of members here. There might be someone close to you.


R
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top