Honda CX 500 Forum banner

clutch spring

1277 Views 6 Replies 5 Participants Last post by  Randall-in-Mpls
Hi All,

You know the seal in the front of the bike in the clutch cover that always leaks? It's the tiny seal on the shaft with the clutch lever in the front of the motor. Well, the other day I was replacing that seal and in the process I destroyed the spring on that shaft. I now have the new spring, the seal is fixed and I am ready to put it back together but I need to know the trick in setting the shaft in the right position with the propler tension on the spring. How is this done?

1 - 1 of 7 Posts
If its not already done, you should try to make sure the actuator arm is around the nine o'clock position for the proper travel on the clutch cable. At least I THINK thats correct. I'm sure I'd get corrected if not.

Joel in the Couve
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.