Honda CX 500 Forum banner

CBR F2 Front End Swap?

2812 Views 12 Replies 5 Participants Last post by  50gary
OK, so I couldn't pass this one up. I now have a pretty nice set of forks, triples, etc to meld to my cafe project (which is just about to really begin now that the bike is rideable). I'm hoping some of you might have done this already or could give me some things to look for/think about as the process starts. I'm thinking sometime in November I'll post a "project thread". I know the bike is junk, but the only parts I really needed was the front. Actually, there are some other parts worth recycling, I'm just not sure they are good for the CX. Anyone to buy a 91 F2 rear wheel?


See less See more
1 - 2 of 13 Posts
I'd bet the taillight would look cool in a cafe seat? The foot controls would be a pretty nice upgrade too. The radiator fan might work to elminate the mechanical CX fan? You could part it out on the bay an make a lot more than $50. Sell "D" the exhaust can.

Cheers, 50gary
Someone was asking the length of the steering stem. It's 9,15/16" >252mm.

Cheers, 50gary
1 - 2 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.