Honda CX 500 Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Do I need any adhesive to mount airboots at the intake? I feel as they should mate them self but totally don't know.
 

·
Registered
Joined
·
1,537 Posts
the join of boot to carb or boot to cylinder head?

The head joint seals with an o-ring , the carb joint is sealed with the thin clamp that fits inside the groove on the rubber. New clamps are too wide to sit down in the groove ....
 

·
Super Moderator
Joined
·
3,785 Posts
The OP has acquired new rubber for the insulator so is asking how to attach the rubber to the aluminium runner. I would think that a fuel resistant adhesive would be in order.
 

·
Registered
Joined
·
6,518 Posts
The OP has acquired new rubber for the insulator so is asking how to attach the rubber to the aluminium runner. I would think that a fuel resistant adhesive would be in order.
That was not clear in the OP??
 

·
Super Moderator
Joined
·
3,785 Posts
True, but I saw him ask the question, with pictures, on one of the facebook groups.
 

·
Super Moderator
Joined
·
3,785 Posts
Facebook is that annoying web page where you can see something of interest and never be able to find it again. :unsure::mad:
 
1 - 8 of 8 Posts
Top