Honda CX 500 Forum banner
Cancel

Media added by RinoStoof

Navigation

Browse albums
Thermostat switch on bottom of radiator. This drives a relay which drives the fan. I will mount a second in parallel just to have some redundancy.

Thermostat switch on bottom of radiator. This drives a relay which drives the fan. I will mount a second in parallel just to have some redundancy.

  • 0
  • 0
Hmm, I tried to be tidy and logical here...

Hmm, I tried to be tidy and logical here...

  • 0
  • 0
The original plastic rear covers were missing so I made some up out of a bit of aluminium.

The original plastic rear covers were missing so I made some up out of a bit of aluminium.

  • 0
  • 0
The LED daymaker from aliexpress along with the spotlight make a HUGE difference. About $100 for both!! Not the classic look but I like seeing what I'

The LED daymaker from aliexpress along with the spotlight make a HUGE difference. About $100 for both!! Not the classic look but I like seeing what I'

  • 0
  • 0
Didn't know what to do with 2 large holes in bottom of guard so I put some LED lights there. The seat back is just held by a bit of folded aluminium.

Didn't know what to do with 2 large holes in bottom of guard so I put some LED lights there. The seat back is just held by a bit of folded aluminium.

  • 0
  • 0
Front view, love those LED lights!

Front view, love those LED lights!

  • 0
  • 0
Ignition unit from Ray-San. Installed in 30 mins using crystal clear instructions. Works like a charm! Only $200 australian! You could maybe do this w

Ignition unit from Ray-San. Installed in 30 mins using crystal clear instructions. Works like a charm! Only $200 australian! You could maybe do this w

  • 0
  • 0
Ire pressure on left, radiator water warning (green now, red and beeping when too low) on right. The buttons are to test and reset electronics. Just a

Ire pressure on left, radiator water warning (green now, red and beeping when too low) on right. The buttons are to test and reset electronics. Just a

  • 0
  • 0
Mounted 4mm brass bolts with rubber grommets into holes in top tank. These are connected to a small circuitboard that detects the higher resistance wh

Mounted 4mm brass bolts with rubber grommets into holes in top tank. These are connected to a small circuitboard that detects the higher resistance wh

  • 0
  • 0
Testing home made windscreen deflector, makes a huge difference!

Testing home made windscreen deflector, makes a huge difference!

  • 0
  • 0
Electric fan fitted in original shroud using its plastic side mounts. Had to cut of front of cam shaft to make it fit. Uses thermostat switch araldite

Electric fan fitted in original shroud using its plastic side mounts. Had to cut of front of cam shaft to make it fit. Uses thermostat switch araldite

  • 0
  • 0
Trimmed of cam shaft.

Trimmed of cam shaft.

  • 0
  • 0
This shows the fan bolts in the old shroud. I had not planned to re-use this hence it still being in its original state. I spent a lot of time polishi

This shows the fan bolts in the old shroud. I had not planned to re-use this hence it still being in its original state. I spent a lot of time polishi

  • 0
  • 0
I used a whole bunch of LED strips on some plastic sheeting. A resistor dims it for tail while the brake runs through a fast blinking unit to make it

I used a whole bunch of LED strips on some plastic sheeting. A resistor dims it for tail while the brake runs through a fast blinking unit to make it

  • 0
  • 0
How it started, a little neglected..

How it started, a little neglected..

  • 0
  • 0
Top