4. Just about down to the base requirements before rebuilding. Note the pod filters on to protect the carb inlets. I wanted the bike back on the road

7. Wiring loose ends. New rear light and indicators.

6. The flip side of the build.

5. Rear subframe cut with the new module welded in and painted. I have fitted the aftermarket rear shocks. There is a little bit of wiring to do to g

4. Just about down to the base requirements before rebuilding. Note the pod filters on to protect the carb inlets. I wanted the bike back on the road

2. The beginning of the "stripping down" process.

1. The GL500 as purchased.

4. Just about down to the base requirements before rebuilding. Note the pod filters on to protect the carb inlets. I wanted the bike back on the road

BisonInExile
May 29, 2016

Watch Add bookmark

There are no comments to display.