CX500 GL500 Transverse Twins Discussion Forum
CX Customization & Modifications
TURBO
Other Forums
Honda Grom Forum / MSX125 Forum
If you are interested in the new Honda Grom or Honda MSX125 please check out the Honda Grom Forum @ HondaGrom.net
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
CX500 Regional Forums
CX500 International Forums
Latest Posts
-
Midwest RidersJust bought a 81 cx500 that was in a shop fire Took the head caps off seen frothy oil Drained the oil and it looked like chocolate milk Where should I start looking for the leak
- 4
- 63
-
Technical Help ForumI inherited a 82 cx500. Most of the wiring was set up , but I find myself at a dead end I have a few wires that I can't seem to name, and all the wires from the starter switch/right handle bar I have no way to hook up currently -- I don't know if I need to change a connector or if I am missing...
- 8
- 206
-
Midwest RidersMN Spring Ride XV The 15th annual Twin Cities Spring Ride and Barbecue will be Saturday, June 4, 2022. Proposed itinerary: 9:00 Muster at Kwik Trip #640 in Pine Island, MN. (This is further south than in previous years.) 9:30 - 11:00 Pine Island to Winona (77.4 miles, 1:33) 11:00 - 11:30...
- 21
- 749
-
Technical Help ForumMy clutch is slipping a bit, not sure of actual miles, but adjustments do not seem to be helping. It's fine taking off but while engaged, it slips if I roll-on quickly. I plan to adjust once again, but if no luck, a replacement. Any recomendations of brand or place of purchase, shall I swap...
- 4
- 91
-
General DiscussionI just swapped out my factory handlebars for Daytonas, and so far I like them much better except for the vibration. My hands are getting numb from the vibration within a couple of miles. These new ones were pretty cheap, so the walls aren't quite as thick as the factory bars, which I'm assuming...
- 8
- 365